Locating Signals
The AM Mod signal is centered around ground.
Set the oscilloscope trigger level to either the top or bottom of t he wa veform to stabilize it on the display.
Single Shot Pulse
Board label. SS_PULSE
Connector grid location. C5, I4
Description. This is a 200 ns wide positive pulse that is initiated by the SINGLE SHOT push button (grid location I4). The Demo
2 boa rd provides one pulse per button push.
512 MHz
Board label. 512_MHZ
Connector grid location. C6
Description. This is a 512 MHz, 600 m V peak-to-peak sine wave s ign al that is enabled by the SINGLE SHOT push button
(grid location I4).
FlexRay
Board label. FLEXRAY_BP, FLEXRAY_BM, FLEXRAY_TX/RX
Demo 2 Board Instruction Manua l 125
To Next Page
Loading...
Need help?
General
