Command Syntax
General Rules for Using
SCPI Commands
The following a
re three general rules for using SCPI commands, queries, and
parameters:
You c a n us e sin
gle (‘ ’) or double (“ ”) quotation marks for quoted strings, but
you cannot use both types of quotation marks for the same string.
correct
“This string uses quotation marks correctly.”
correct
‘This string also uses quotation marks correctly.’
incorrect “This strin
g does not use quotation marks correctly.’
You can use upper case, lower case, or a mixture of both cases for all
commands, queries, and parameters.
:SOURCE:FREQUENCY 10MHZ
is the same as
:source:frequency 10mhz
and
:SOURCE:frequency 10MHZ
NOTE. Q
uoted strings are case sensitive.
No embedded spaces are allowed between or within nodes.
correct
:OUTPUT:FILTER:LPASS:FREQUENCY 200MHZ
incorrect
:OUTPUT: FILTER: LPASS:FREQUENCY 200M HZ
2-6 Series 2200 Programmable Multichannel D C Power Supplies Programmer Manual
To Next Page
Loading...
Need help?
General
