Tektronix MSO2014 Programmer's Manual

Commands Listed in Alphabetical Order
CURSor:XY:PR
ODUCT:POSITION<x>? (Query Only)
Returns the position of the X or Y cursor used to calculate the X × Y cursor
measurement, Position 1 = (X1 × Y1); Position 2 = (X2 × Y2). The cursor is
specified by x
, which can be 1 or 2.
Group
Cursor
Syntax
CURSor:XY:PRODUCT:POSITION <x>?
CURSor:XY:PRODUCT:UNIts? (Query Only)
Returns the XY cursor product units.
Group
Cursor
Syntax
CURSor:XY:PRODUCT:UNIts?
CURSor:XY:RATIO:DELta? (Query Only)
Returns the ratio of the difference b etween the cursors X position and cursor Y
position (ΔY¸ ΔX). The ratio is calculated as (Y2 – Y1) / (X2 – X1).
Group
Cursor
Syntax
CURSor:XY:RATIO:DELta?
CURSor:XY:RATIO:POSITION<x>? (Query Only)
Returns the X (horizontal) or Y (vertical) position for the specified cursor, which
can be 1 (X) or 2 (Y). The ratio is calculated as Position 1 = (Y1/X1); Position
2 = (Y2/X2).
Group
Cursor
Syntax
CURSor:XY:RATIO:POSITION<x >?
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-121

Tektronix MSO2014 Specifications

General

Brand	Tektronix
Model	MSO2014
Category	Test Equipment
Language	English