Commands Listed in Alphabetical Order
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:POLarity
{NEGative|POSitive}
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:POLarity?
Arguments
POSITIVe places a mark only when the polarity of the pulse is positive.
NEGative places a mark only when the polarity of the pulse is negative.
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:SOUrce
Sets or returns the source waveform for a pulse trigger search to determine where
to place a mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:SOUrce
{CH1|CH2|CH3|CH4|MATH|REF }
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:SOUrce?
Arguments
CH<x> specifies one input channel as the edge source, where <x> = 1, 2, 3 or 4.
MATH specifies the math waveform as the search source.
REF specifies the reference waveform as the searc
hsource.
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:WHEn
Sets or returns the condition for generating a pulse width search to determine
where to place a mark. <x> is the search number.
Group
Search
Syntax
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:WHEn
{LESSthan|MOREthan|EQual| UNEQual}
SEARCH:SEARCH<x>:TRIGger: A:PULSEWidth:WHEn?
Arguments
LESSThan places a m
ark if the pulse width is less than the time set by the
SEARCH:SEARCH<x>:TRIGger:A:PULSEWidth:WIDth command.
2-274 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
