To Next Page

To Previous Page

Commands Listed in Alphabetical Order

SEARCH:SEARC

H<x>:TRIGger:A:RUNT:SOUrce

Sets or returns the source setting for a runt trigger search to determine where to

place a mark. <x> is the search number.

Group

Syntax

SEARCH:SEARCH<x>:TRIGger: A:RUNT:SOUrce

{CH1|CH2|CH3|CH4|MATH|REF }

SEARCH:SEARCH<x>:TRIGger: A:RUNT:SOUrce?

Arguments

CH1–CH4 speciﬁes an input channel as the edge source.

MATH speciﬁes the math waveform as the search source.

REF speciﬁes the reference waveform as the search source.

SEARCH:SEARCH<x>:TRIGger:A:RUNT:WHEn

Sets or returns the condition setting for a runt trigger search to determine where to

place a mark. <x> is the search number.

Group

Syntax

SEARCH:SEARCH<x>:TRIGger: A:RUNT:WHEn

{LESSthan|MOREthan|EQual| UNEQual|OCCURS}

SEARCH:SEARCH<x>:TRIGger: A:RUNT:WHEn?

Arguments

OCCURS argument speciﬁes a t rigger event if a runt of any detectable width occurs.

LESSthan argument sets the oscilloscope to trigger if the a runt pulse is detected

with width less than the time set by the SEARCH:SEARCH<x>:TRIGger:A:

RUNT:WIDth command.

MOREthan argument sets the oscilloscope to trigger if the a runt pulse is detected

with width more than the time set by the SEARCH:SEARCH<x>:TRIGger:A:

RUNT:WIDth command.

EQUal argument sets the oscilloscope to trigger when the pattern is true for a time

period equal to the time period speciﬁed in SEARCH:SEARCH<x>:TRIGger:A:

RUNT:WIDth within a ± 5% tolerance.

NOTEQual argument sets the oscilloscope to trigger when the pattern is true for a

time p eriod greater than or less than (but not equal) the time period speciﬁed in

SEARCH:SEARCH<x>:TRIGger:A:R

UNT:WIDth within a ±5% tolerance.

2-276 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix MSO2014 Programmer's Manual

Other manuals for Tektronix MSO2014