To Next Page

To Previous Page

Commands Listed in Alphabetical Order

Syntax

SELect {ON|OFF

}

Arguments

ON turns the selected waveform display on.

OFF turns the selected waveform display off.

Examples

SELECT? might return the following

:SELECT:BUS1 0;BUS2 0;CH1 1;CH2 0;CH3 0; CH4 0;MATH 0;REF1

0;REF2 0;D0 0;D1 0;D2 0;D3 0;D4 0;D5 0;D6 0;D7 0;D8 0;D9

0;D10 0 ;D11 0;D12 0;D13 0;D14 0;D15 0,CONTROL CH1

SELect:BUS<x>

This command turns on and off the display of the waveform for <x>, where x is

the bus number. The query returns whether the c hannel is on or off but does not

indicate whether it is the selected waveform.

Group

Vertical

Syntax

SELect:BUS<x> {<NR1>|OFF|ON}

SELect:BUS<x>?

SELect:CH<x>

Turns the display of the channel <x> waveform on or off, where <x > is the

channel number. This command also resets the acquisition. The query returns

whether the channel is on or off but does not indicate whether it is the selected

waveform.

Group

Vertical

Syntax

SELect:CH<x> {ON|OFF|<NR1>}

SELect:CH<x>?

Arguments

ON turns on the display of the speciﬁed waveform. This waveform also becomes

the selected waveform.

OFF turns o ff the display of the speciﬁed waveform.

<NR1> = 0 turns off the display of the speciﬁed waveform; any other value turns

on the display of the speciﬁed waveform.

MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-285

Tektronix MSO2014 Programmer's Manual

Other manuals for Tektronix MSO2014