Commands Listed in Alphabetical Order
Arguments
<NR1> is a value
in the range from 0 through 255. The binary bits of the SRER
are set according to this value. Using an out-of-range value causes an execution
error. The power-on d efault for SRER is 0 if *PSC is 1. If *PSC is 0, the SRER
maintains the previous power cycle value through the current power cycle.
Examples
*SRE 48 sets the bits in the SRER to binary 00110000.
*SRE? might return 32, showing that the bits in the SRER have the binary value
of 00100000.
*STB? (Query Only)
*STB? (Read Status Byte) returns the contents of the Status Byte Register (SBR)
using the Master Summary Status (MSS) bit. For information, refer to Registers.
Group
Status and Error
Syntax
*STB?
Related Commands
*CLS, DESE, *ESE, *ESR?, EVENT?, EVMsg?, FACtory, *SRE
Returns
<NR1>
Examples
*STB? might return 96, showing that the SBR contains the binary value 01100000.
TEKSecure (No Query Form)
This command initializes both waveform and setup memories, overwriting
any previously stored data. These are the WFMInpre?, WFMOutpre?,
DATa, DATa:RESOlution and DATa:COMPosition command values after the
TEKSecure operation.
:WFMOUTPRE:BYT_NR 1 :WFMOUTPRE:BIT_NR 8 :WFMOUTPRE:EN CDG BIN
:WFMOUTPRE:BN_FMT RI :WFMOUTPRE:BYT_OR MSB :WFMOUTPRE:WF ID
"Ch1, D C coupling, 100.0mV/div, 4.000us/div, 10000 points,
Sample mode" :WFMOU TPRE:NR_PT 10000 :WFMO UTPRE:PT_FMT
Y :WFMO UTPRE:XUNIT "s" :WFMOUTPRE:XINCR 4 .0000E-9
:WFMOUTPRE:XZERO -20.0000E-6 :WFMOUTPRE:PT_OFF 0
:WFMOUTPRE:YUNIT "V" :WFMOUTPRE:YMULT 4.0000 E-3
:WFMOUTPRE:YOFF 0.0000 :WFMOUTPRE:YZERO 0.00 00
:WFMINPRE:BYT_NR 1 :WFMINPRE:BIT_NR 8 :WFMINPRE:ENCDG BIN
:WFMINPRE:BN_FMT RI :WFMINPRE:BYT_OR MSB :WFMINPRE:NR_PT
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-291
To Next Page
Loading...
Need help?
General
