To Next Page

To Previous Page

Commands Listed in Alphabetical Order

Group

Waveform Trans

fer

Syntax

WFMOutpre:XZEro?

Related Commands

DATa:SOUrce, WFMOutpre:XUNit?

Examples

WFMOUTPRE:XZERO? might return :WFMOUTPRE:XZERO 5.6300E-9 indicating

that the trigger occurred 5.63 ns before the ﬁrst sample in the waveform record.

WFMOutpre:YMUlt? (Query Only)

Returns the vertical scale factor per digitizing level in units speciﬁed by

WFMOutpre:YUNit for the waveform speciﬁed by the DATa:SOUrce command.

The query command will time out and an error is generated if the waveform

speciﬁed by DATa:SOUrce is not turned on.

See the description of WFMInpre:YMUlt to see how this scale factor is used to

convert waveform sample values to volts.

Group

Waveform Transfer

Syntax

WFMOutpre:YMUlt?

Related Commands

DATa:SOUrce, WFMInpre:YMUlt

Examples

WFMOUTPRE:YMULT? might return :WFMOUTPRE:YMULT 4.0000E-3 indicating

that the vertical scale for the corresponding waveform is 100 mV/div (for 8-bit

waveform data).

WFMOutpre:YOFf? (Query Only)

Returns the vertical position in digitizing levels for the waveform speciﬁed by the

DATa:SOUrce command. The query command will time out and an error will be

generated if the waveform speciﬁed by DATa:SOUrce is not turned on.

See the description of WFMInpre:YOFf to see how this position is used to convert

waveform sample values to volts.

Group

Waveform Transfer

2-372 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual

Tektronix MSO2024 Programmer's Manual

Other manuals for Tektronix MSO2024