To Next Page

To Previous Page

Commands Listed in Alphabetical Order

Syntax

WFMOutpre:YOF

Related Commands

DATa:SOUrce, WFMOutpre:BYT_Nr

Examples

WFMOUTPRE:YOFF? might return :WFMOUTP RE:YOFF -50.0000E+0 indicating

that the position indicator for the waveform was 50 digitizing levels (2 divisions)

below center screen (for 8-bit waveform data).

WFMOutpre:YUNit? (Query Only)

Returns the vertical units for the waveform speciﬁed by the DATa:SOUrce

command. The query command will time out and an e rror will be generated if the

waveform speciﬁed by DATa:SOUrce is not turned on.

Group

Waveform Transfer

Syntax

WFMOutpre:YUNit?

Related Commands

DATa:SOUrce

Examples

WFMOUTPRE:YUNIT? might return :WFMOUTPRE:YUNIT "dB" indicating that

the v ertical units for the waveform are measured in decibels.

WFMOutpre:YZEro? (Query Only)

Returns the vertical offset in units speciﬁed by WFMOutpre:YUNit? for the

waveform speciﬁed by the DATa:SOUrce command. The query command will

time out and an error will be generated if the waveform speciﬁed by DATa:SOUrce

is not turned on.

See the description of WFMInpre:YZEro to see how this offset is used to convert

waveform sample values to volts.

Group

Waveform Transfer

Syntax

WFMOutpre:YZEro?

Related Commands

DATa:SOUrce, WFMOutpre:YUNit?

MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-373

Tektronix MSO2024 Programmer's Manual

Other manuals for Tektronix MSO2024