Commands Listed in Alphabetical Order
DIAg:SELect (
No Query Form)
Sets the type of diagnostics grouping.
Group
Calibration a nd Diagnostic
Syntax
DIAg:SELect {ALL|APPKey|CPU|DISplay|FP Anel|IO|ROM|ACQ }
Arguments
ALL runs all diagnostic groups.
APPKey runs just the application key diagnostic group.
CPU runs just the CPU diagnostic group.
DISplay runs just the display circuit diagnostic group.
FPAnel runs just the front panel diagnostic group.
IO runs just the IO board diagnostic group.
ROM runs just the IO board diagnostic group.
ACQ runs just the acquisition system diagnostic group.
DIAg:SELect:<function> (No Query Form)
Runs self-tests on the specified
system subsystem.
Group
Calibration a nd Diagnostic
Syntax
DIAg:SELect:<function>
Arguments
<function> specifies a single oscilloscope subsystem on which to run self tests
(diagnostics). Valid values are:
ACQ tests the acquisition system.
APPKey tests the application keys.
CPU tests the CPU.
DISplay tests the display.
FPAnel tests the front panel controls.
IO tests the IO ports.
ROM tests the system rea d only memory.
2-138 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
