Compliance information
1
This product is intended for use in nonresidential areas only. Use in residential areas
may cause electromagnetic interference.
2
Emissions which exceed the levels required by this standard may occur when this
equipment is connected to a test o
bject.
3
For compliance with the EMC standards listed here, high quality shielded interface
cables should be used.
Australia / New Zealand Declara
tion of Conformity – EMC
Complies with the EMC provision of the R adiocom munications Act per
the following standard, in a
ccordance with ACMA:
CISPR 11. R adiated and Conducted Emissions, Group 1, Class A,
in accordance with EN 6132
6-1.
Australia / New Zealand contact.
Baker & McKenzie
Level 27, AM P Centre
50 Bridge Street
Sydney NSW 2000, Australia
10 RSA306 Installation an d Safety Instructions
To Next Page
Loading...
