Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–95
*DDT?
<QString>
*DDT
<Space>
?
<Block>
<Block> or <QString> is a complete sequence of program messages. The
messages can contain only valid commands that must be separated by semico-
lons and must follow all rules for concatenating commands (see page 2–4). The
sequence must be ≤80 characters. <Block> format is always returned as a query
response.
*DDT #0ACQUIRE:STATE RUN;BELL<EOI>
specifies that the acquisition system will be started and the bell rings each time a
*TRG command is sent.
DELEte:SETUp (No Query Form)
Removes stored setups from memory and initializes the location with the factory
default setup.
NOTE. The setup information cannot be recovered once it has been deleted.
Save and Recall
*RCL, RECAll:SETUp, *RST, *SAV, SAVe:SETUp, TEKSecure
DELEte:SETUp { <NR1> | ALL }
DELEte :
SETUp
<Space>
ALL
<NR1>
<NR1> is a value in the range 1 to 10, and specifies a setup storage location.
Using an out-of-range value causes an execution error.
ALL specifies all the stored setups.
Arguments
Examples
Group
Related Commands
Syntax
Arguments
To Next Page
Loading...
Need help?
General
