Command Descriptions
2–100
TDS Family Oscilloscope Programmer Manual
selects functional, memory, and register tests.
DIAg:SELect:DISplay (No Query Form)
Selects the display system test sequence that will be run when the DIAg:STATE
EXECUte command is sent. This command is equivalent to setting Area in the
Utility menu when System is set to Diag/Err.
Calibration and Diagnostic
selects functional, memory, and register tests.
DIAg:SELect:FPAnel (No Query Form)
Selects the front-panel test sequence that will be run when the DIAg:STATE
EXECUte command is sent. This command is equivalent to setting Area in the
Utility menu when System is set to Diag/Err.
Calibration and Diagnostic
selects self diagnostic tests.
Arguments
Group
Syntax
Arguments
Group
Syntax
Arguments
To Next Page
Loading...
