Command Descriptions
2–52
TDS Family Oscilloscope Programmer Manual
by commas. Use the *ESR? query to enable the events to be returned. For a
complete discussion of the use of these registers, see page 3–1. This command is
similar to repeatedly sending *EVMsg? queries to the instrument.
Status and error
*CLS, DESE, *ESE, *ESR?, EVENT?, EVMsg?, EVQTY, *SRE, *STB?
ALLEv?
ALLEv ?
The event code and message in the following format:
<Event Code><Comma><QString>[<Comma><Event Code><Comma>
<QString>...]
<QString>::= <Message>;[<Command>]
<Command> is the command that caused the error and may be returned when a
command error is detected by the digitizing oscilloscope. As much of the
command will be returned as possible without exceeding the 60 character limit
of the <Message> and <Command> strings combined. The command string is
right-justified.
ALLEV?
might return the string :ALLEV 2225,"Measurement error, No waveform to
measure; ",420,"Query UNTERMINATED; ".
ALLOcate? (Query Only)
Returns the number of data points allocated for all four reference memory
locations.
Save and Recall
ALLOcate?
ALLOcate ?
Group
Related Commands
Syntax
Returns
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
