Warranted Characteristics
TDS 500D, TDS 600C, TDS 700D & TDS 714L Performance Verification and Specifications
2–27
Table 2–15: Certifications and compliances
EC Declaration of Conformity —
EMC
3
(TDS 500D, TDS 700D,
and TDS 714L)
Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European Union:
EN 55011 Class A Radiated and Conducted Emissions
EN 50081-1 Emissions:
EN 60555-2 AC Power Line Harmonic Emissions
EN 50082-1 Immunity:
IEC 801-2 Electrostatic Discharge Immunity
IEC 801-3 RF Electromagnetic Field Immunity
IEC 801-4 Electrical Fast Transient/Burst Immunity
IEC 801-5 AC Power Line Surge Immunity
EC Declaration of Conformity —
EMC
3
(TDS 600C)
Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European Union:
EN 55011 Class A Radiated and Conducted Emissions
IEC 61000-3-2 AC Power Line Harmonic Emissions
EN 50082-1 Immunity:
IEC 61000-4-2 Electrostatic Discharge Immunity
IEC 61000-4-3 RF Electromagnetic Field Immunity
IEC 61000-4-4 Electrical Fast Transient/Burst Immunity
IEC 61000-4-5 AC Power Line Surge Immunity
IEC 61000-4-6 RF Conducted Immunity
IEC 1000-4-8 Magnetic Field Immunity
IEC 1000-4-11 AC Power Line Interruption Immunity
Australia/New Zealand
Declaration of Conformity – EMC
Complies with EMC provision of Radiocommunications Act per the following standard(s):
AS/NZS 2064.1/2 Industrial, Scientific, and Medical Equipment: 1992
EC Declaration of Conformity –
Low Voltage
Compliance was demonstrated to the following specification as listed in the Official Journal of the
European Communities:
Low Voltage Directive 73/23/EEC, amended by 93/69/EEC
EN 61010-1/A2:1995 Safety requirements for electrical equipment for measurement,
control, and laboratory use
3
To ensure compliance with EMC requirements, only high quality shielded cables having a reliable, continuous outer
shield with full coverage and low impedance connections to shielded connector housings at both ends should be
connected to this product. The following cables, or their equivalent, may be used:
GPIB: Tektronix P/N 012–0991–00, –01, –02, or –03
RS–232: Computer Accessories P/N CA 0294–9
Centronics: Tektronix P/N 012–1214–00
VGA: LCOM P/N CTL3VGAMM–5 (if connected, terminate the cable)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
