Command Descriptions
2−102
TDS200/1000/2000 Series Oscilloscope Programmer Manual
ID? (Query Only)
Returns identifying information about the oscilloscope and its
firmware in Tektronix Codes and Formats notation.
NOTE. ID? must be the last command when it is part of a concate-
nated statement. Otherwise the oscilloscope generates event message
440.
Status and Events
ID?
The oscilloscope identification in the following format:
TEK/<model number>,CF:91.1CT,FV:v<oscilloscope firmware
version number>,TDS2XX:XXV:v<module firmware version
number>
Where XX is the module type, CM (communications module) or
MM (measurement module).
The *IDN? and ID? responses are slightly different.
ID?
might return the response
ID TEK/TDS 220,CF:91.1CT,FV:v1.00 TDS2CM:CMV:v1.00
*IDN?
Group
Syntax
Returns
Examples
Related Commands
To Next Page
Loading...
