Tektronix TDS3034

Service Manual
TDS3000 Series
Digital Phosphor Oscilloscopes
071-0382-01
This document supports firmware version 2.00
and above.
Warning
The servicing instructions are for use by qualified
personnel only. To avoid personal injury, do not
perform any servicing unless you are qualified to
do so. Refer to all safety summaries prior to
performing service.

Tektronix TDS3034 Specifications

General

Bandwidth	300 MHz
Channels	4
Sample Rate	2.5 GS/s
Vertical Resolution	8 bits
Display Type	Color LCD
Input Voltage Range	±5 V
Weight	6.8 kg (15 lbs)
Input Coupling	AC, DC, GND
Timebase Accuracy	50 ppm
Record Length	10 Mpoints
Memory Depth	10 k points
Rise Time	1.2 ns
Input Impedance	1 MΩ
Maximum Input Voltage	300 V
Trigger Modes	Edge, Pulse, Video, Logic
Display	Color
Power Requirements	100-240 VAC, 45-440 Hz

Summary

Warranty

Specifications

Operating Information

Connecting Power and Battery Usage

How to connect AC power and use battery operation.

Front-Panel Controls and Menus

Overview of front panel buttons, menu navigation, and controls.

Theory of Operation

Power Supply and Battery Board

Main Board Systems

Details the main board's acquisition, trigger, display, and processor systems.

Performance Verification

Self Test Procedure

Key Performance Checks

Procedures for verifying DC voltage accuracy, bandwidth, and trigger sensitivity.

Adjustment Procedures

Signal Connections and Procedures

Details signal connections and step-by-step factory adjustment procedures.

Maintenance

Preparation and ESD Prevention

Inspection and Cleaning

Removal and Installation Procedures

Step-by-step guides for removing and installing major modules.

Troubleshooting and Repair Adjustment

Guides for isolating failures and adjusting after repair.

Mechanical Parts List

Parts Ordering Information

Using the Replaceable Parts List