Tektronix TDS3012B User Manual

University of Portland - p. 1 of 9 - Oscilloscope - TDS3012B.docx
Oscilloscope Tutorial
Tektronix TDS3012B and TDS3012
Figure 1: Oscilloscope with a 10X probe connected to the Probe Comp Terminals
Introduction
The oscilloscope, which displays voltage versus time, is an indispensable tool for testing and
troubleshooting circuits and taking electrical measurements. This tutorial will explain how to set
up the oscilloscope and take basic measurements.
Getting Started
Do the following steps to set up the oscilloscope.
1. Turn on the oscilloscope by pressing the power button located in the lower left-hand
corner. Wait for scope to boot-up. When a message shows up on the screen, press the
MENU OFF button.
2. When the oscilloscope powers up, it uses the settings that were in place when it was last
powered down. To return the oscilloscope to the factory settings, press the Save/Recall
button. Then press the button under the screen labeled Recall Factory Setup. Next press
the button on the right of the screen labeled OK Confirm Factory Init.

Tektronix TDS3012B Specifications

General

Bandwidth	100 MHz
Channels	2
Sample Rate	1.25 GS/s
Time Base Range	5 ns/div to 50 s/div
Vertical Resolution	8 bits
FFT	Yes
Display	5.7-inch color LCD
Vertical Sensitivity	2 mV/div to 5 V/div
Input Impedance	1 MΩ ± 2%
Trigger Modes	Edge, Pulse Width, Video, Logic
Power Supply	100-240 VAC, 45-440 Hz
Interfaces	GPIB (optional)