To Next PageTo Next Page
Need help?Do you have a question about the Tektronix TDS3012 and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Channels | 2 |
| Sample Rate | 1.25 GS/s |
| Display | Color LCD |
| Vertical Resolution | 8 bits |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Timebase Range | 5 ns/div to 50 s/div |
| Trigger Modes | Edge, Pulse |
| Interfaces | RS-232 |
| Input Impedance | 1 MΩ |
| Power Supply | 100-240 VAC |
| Weight | 3.2 kg |
Precautions to prevent fire and injury during product use.
Precautions to prevent damage from static discharge.
Warning against performing service without assistance.
Instruction to disconnect power before servicing.
Caution regarding hazardous voltages during servicing.
Defines acquisition modes and parameters.
Details input impedance, voltage limits, and crosstalk.
Specifies vertical scale, bandwidth, and other vertical parameters.
Adjusting the oscilloscope probe for accurate measurements.
Routine to optimize signal path for measurement accuracy.
Procedure for running internal self-tests.
Steps to verify DC voltage measurement accuracy.
Procedure to test channel bandwidth.
Test for edge-trigger sensitivity.
Procedure to verify time base and delay time accuracy.
Step-by-step guide for factory calibration.
Precautions to prevent ESD damage during maintenance.
Guides for removing and installing modules.
Information and procedures for isolating defective modules.
Flowcharts for diagnosing instrument failures.
Initial flowchart for diagnosing instrument issues.
Flowchart for troubleshooting power-up issues.
Flowchart for AC power supply problems.
Flowchart for battery module issues.
Flowchart for front panel/backlight power.
Flowchart for display/main module voltage issues.
Flowchart for isolating specific failed modules.
