Tektronix TDS3032

Service Manual
TDS3000 Series
Digital Phosphor Oscilloscopes
071-0382-01
This document supports firmware version 2.00
and above.
Warning
The servicing instructions are for use by qualified
personnel only. To avoid personal injury, do not
perform any servicing unless you are qualified to
do so. Refer to all safety summaries prior to
performing service.

Tektronix TDS3032 Specifications

General

Brand	Tektronix
Model	TDS3032
Category	Test Equipment
Language	English

Summary

General Safety Summary

To Avoid Fire or Personal Injury

Safety precautions for preventing fire and personal injury during operation.

Preventing Electrostatic Damage

Service Safety Summary

Safety precautions specific to performing service procedures on the instrument.

Specifications

Operating Information

Connecting Power

Front-Panel Menus and Controls

Overview of front-panel buttons, knobs, and menu system navigation.

Probe Compensation

Procedure for adjusting the probe to match the input channel for accurate measurements.

Performance Verification

Performance Verification Procedures

General requirements and steps for verifying instrument performance against specifications.

Self Test

Internal routines to verify oscilloscope functions and pass self tests without external equipment.

Check DC Voltage Measurement Accuracy

Procedure to test the accuracy of DC voltage measurements in average acquisition mode.

Check Bandwidth

Adjustment Procedures

Overview of the Adjustment Process

Factory Adjustment Procedure

Step-by-step instructions for performing the oscilloscope's factory calibration.

Maintenance

Removal and Installation Procedures

Troubleshooting

Information and procedures for isolating defective modules within the oscilloscope.