Command Descriptions
2−124
TDS200/1000/2000 Series Oscilloscope Programmer Manual
*RCL 3
restores the oscilloscope from a copy of the settings stored in
memory location 3.
FACtory, *LRN?, RECAll:SETUp, *RST, *SAV, SAVe:SETUp
RECAll:SETUp (No Query Form)
Restores a stored or factory front-panel setup of the oscilloscope.
This command is equivalent to selecting Recall Setup or Recall
Factory in the Save/Recall Setup menu.
Save and Recall
RECAll:SETUp { FACtory | <NR1> }
FACtory selects the factory setup.
<NR1> is a value in the range from 1 to 5 (TDS200 series) or 10
(TDS1000 and TDS2000 series) and specifies a setup storage
location.
RECALL:SETUp FACtory
recalls the front-panel setup to its factory defaults.
FACtory, *RCL, *RST, *SAV, SAVe:SETUp
Examples
Related Commands
Group
Syntax
Arguments
Examples
Related Commands
To Next Page
Loading...
Need help?
General
