Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−157
VERBose ON
sets the Verbose state true.
VERBose?
might return the value 1, showing that the Verbose state is true.
HEADer, *LRN?, SET?
*WAI (No Query Form)
*WAI (wait) prevents the oscilloscope from executing further
commands or queries until all pending operations finish. This
command lets you synchronize the operation of the oscilloscope with
your application program. Refer to Synchronization Methods on
page 3-10 for more information.
Unlike *OPC?, *WAI returns no value when pending operations
finish. Table 2-25 (*OPC) on page 2-121 lists commands that
generate an operation complete message.
Status and Error
*WAI
BUSY?, *OPC
WAVFrm? (Query Only)
Returns WFMPre? and CURVe? data for the waveform specified by
the DATa:SOUrce command. This command is equivalent to sending
WFMPre?; CURVe?. If the waveform specified by the DATa:SOUrce
command is not displayed, the oscilloscope returns only the
waveform transmission parameters (BYT_Nr, BIT_Nr, ENCdg,
BN_Fmt, BYT_Or).
Examples
Related Commands
Group
Syntax
Related Commands
To Next Page
Loading...
Need help?
General
