Tektronix TDS2022C Service Manual

Maintenance
Troubleshooting the
Display
To troubleshoo
t a nonfunctional d isplay, follow these steps:
1. Remove the rear case. (See page 58, Rear Case.)
2. Remove the in t ernal assembly from the fron t case. (See page 61, Internal
Assembly.)
3. Remove the Display module. (See page 66, Display Module.)
4. Reseat the display cable to the Display module, making sure that the cable is
fully seated in the connector.
5. Reconnect the Display module to the internal assembly.
6. Reattach the front panel.
7. Reconnect the backlight and display cables to the Main board.
8. Power on
the oscilloscope. If the display still does not work, contact your
local Tektronix Customer Service Center for assistance.
76 TDS2000C and TDS1000C-EDU Series Oscilloscope Service Manual

Tektronix TDS2022C Specifications

General

Bandwidth	200 MHz
Sample Rate	2 GS/s
Channels	2
Record Length	2.5 kpoints
Timebase Range	5 ns/div to 50 s/div
Math Functions	Add, Subtract, Multiply, Divide, FFT
Input Coupling	AC, DC, GND
Vertical Resolution	8 bits
Trigger Modes	Auto, Normal, Single
Memory Depth	2.5 kpoints
Display	5.7-inch color LCD
Input Impedance	1 MΩ
Trigger Types	Edge, Pulse, Video
Display Resolution	320 x 240 pixels
Connectivity	USB
Automatic Measurements	Frequency, Period, Rise Time, Fall Time
Power Supply	100-240 VAC
Time Base	5 ns to 50 s