Need help?Do you have a question about the Tektronix TDS2001C and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Sample Rate | 1 GS/s |
| Channels | 2 |
| Memory Depth | 2.5 kpts |
| Vertical Resolution | 8 bits |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Timebase Range | 5 ns/div to 50 s/div |
| Display Type | Color LCD |
| Display Resolution | 320 x 240 pixels |
| Connectivity | USB 2.0 |
| Trigger Modes | Auto, Normal, Single |
| Interface | USB 2.0 |
| Display | LCD |
| Trigger Types | Edge, Pulse, Video |
| Display Size | 5.7 inches |
| Input Impedance | 1 MΩ |
| Power Supply | 100 to 240 V ±10%, 50 to 60 Hz |
Safety precautions to avoid injury and prevent damage to the product or connected products.
Essential safety rules for qualified personnel performing service procedures.
List of necessary equipment for performing performance verification procedures.
General conditions and time required before starting verification procedures.
Procedure to test and verify the DC gain accuracy of input channels.
Procedure to check and verify the oscilloscope's analog bandwidth.
Procedure to test and verify the accuracy of the vertical position control.
List of equipment needed to perform calibration and adjustment procedures.
Steps to access and enable the oscilloscope's service and calibration menu.
Detailed steps for performing the factory calibration of the oscilloscope.
Precautions to prevent damage from static discharge when servicing the oscilloscope.
Flowchart to help diagnose and isolate oscilloscope problems.
To Next Page
