To Next PageTo Next Page
Need help?Do you have a question about the Tektronix TDS2024C and is the answer not in the manual?
General| Bandwidth | 200 MHz |
|---|---|
| Channels | 4 |
| Sample Rate | 2 GS/s |
| Display | Color LCD |
| Display Size | 5.7 inches |
| Time Base Range | 5 ns/div to 50 s/div |
| Vertical Resolution | 8 bits |
| Input Coupling | AC, DC, GND |
| Trigger Modes | Auto, Normal, Single |
| Vertical Sensitivity | 2 mV/div to 5 V/div |
| Input Voltage Range | 300 V CAT II |
| Trigger Types | Edge, Pulse, Video |
| Connectivity | USB |
| Input Impedance | 1 MΩ |
| Power Supply | 100 to 240 V ±10%, 50 to 60 Hz |
Precautions to prevent injury and product damage from electrical hazards.
Details of how the oscilloscope acquires signals, including channels and impedance.
Specifications related to the time base and sweep speed of the oscilloscope.
Characteristics and operation of the trigger functions, including types and sensitivity.
Detailed description of the oscilloscope's main acquisition and processing board.
Description of the front panel controls and their interaction with the main board.
Step-by-step guides to verify the oscilloscope's performance against specifications.
Procedure to verify the accuracy of DC gain measurements on all input channels.
Procedure to test the oscilloscope's frequency bandwidth response.
Verifies the accuracy of the time base and sample rate functions.
Procedure to test the sensitivity of edge trigger functions on all input channels.
Verifies trigger sensitivity for external trigger sources.
Procedure to verify the vertical position accuracy of the signal on the display.
Detailed steps for performing factory calibration and adjustments on the oscilloscope.
Precautions to prevent electrostatic discharge damage during servicing procedures.
Procedure for removing and installing the main logic board, sensitive to ESD.
A flowchart to help diagnose problems and identify faulty modules.
