44
GB
TAB. 2
FUNCTION
n. Dip
OFF ON DESCRIPTION NOTE
Step-by-step input
and
radio channel mode
1
•
Open - Stop - Close
During opening, upon pressing the P/Pbutton the gate stops, pressing it again the gate closes.
During closing, upon pressing the P/Pbutton the gate stops, pressing it again the gate opens.
2
•
1
•
Open - Close
During opening, upon pressing the P/Pbutton the gate stops for a few seconds and then closes.
During closing, upon pressing the P/Pbutton the gate stops for a few seconds and then opens.
2
•
1
•
Open
During opening, pressing the P/Pbutton has no effect. During the pause, pressing the P/Pbutton has no effect.
During closing, upon pressing the P/Pbutton the gate stops for a few seconds and then opens.
2
•
Condominium function
1
•
Open - Close
During opening, pressing the P/Pbutton has no effect. During the pause, upon pressing the P/Pbutton the gate closes.
During closing, upon pressing the P/Pbutton the gate stops for a few seconds and then opens.
2
•
Cut out of opening control
Jolly
input mode
3
•
Safety edge
Safety edge activation reverses the direction for a few seconds. After safety edge activation the control unit locks; re-closing is
cancelled. Use a N.C. contact
4
•
3
•
Clock
Upon closing the input that is short-circuited towards the common terminal, the gate opens and remains open until the contact is
broken. Use a N.O. contact
4
•
3
•
Photocell
During both opening and closing, activation of this photocell stops the gate until it is reset. The next movement is always in the
opening direction. Use a N.C. contact
4
•
3
•
Pedestrian access
The gate open spartially for a programmable time (see“pedestrianopeningprogramming”). Use a N.O.contact.
4
•
Pre-flashing light 5
•
Cut out
The flashing light is powered at the same time as the motor.
•
Connected
The flashing light is powered 5 seconds before any movement.
Re-closure 6
•
Cut out
After one complete opening, the control unit only closes again with a manual control.
•
Connected
After one complete opening, the control unit closes automatically after the programmed pause time.
Photo test 7
•
Cut out
Function bypassed
•
Connected
See text at page 42.
Brake 8
•
Cut out
Unless strictly necessary, it is advisable to cut out the brake.
•
Connected
The m. brake serves to overcome the inertia of heavy aut. systems. When the brake is enabled it activates at the end of every m
Slowdown 9
•
Cut out
There is no slowdown in the last part of travel.
•
Connected
With the slowdown function connected, the motor halves its speed towards the end of every gate movement.
Reclosing after the
photoelectric cells
10
•
Cut out
Function bypassed
•
Connected
The activation of photoelectric cell reduces the pause time for whatever is value previously was to 2 seconds.
Note: the standard initial configuration is shown in part 11 of fig. 1
To Next Page
Loading...
