Why Tele Radio Transmitter range is too short?
If the range of your Tele Radio transmitter is too short, it might be due to damaged or incorrectly installed antenna cables or the antenna itself. Try changing the position of the antenna or replacing the antenna cable.
What to do if Tele Radio Transmitter does not work and red light is on?
If your Tele Radio transmitter isn't working, and the LED shows a red light after pressing the start buttons, the battery might be discharged, so try charging the transmitter. Alternatively, a button on the transmitter could be broken, in that case you should contact your dealer.
What to do if Tele Radio Transmitter red LED 3 flashes?
If, when starting the Tele Radio transmitter, the red LED 3 flashes when you press the start buttons simultaneously, it means that the stop button is pressed in. Pull out the stop button.
What to do if Tele Radio 860 red and yellow LEDs flash?
If the red LED and the yellow LED 1 flash when you press the start buttons simultaneously on your Tele Radio transmitter, the processor has detected a fault with the stop button. Push in the stop button without releasing the start buttons. If the stop button is intact LED 2 should start to flash. Pull out the stop button and release the start buttons. If the transmitter does not start after this instruction the stop button needs to be replaced. Contact your dealer.
What to do if receiver yellow LED is not lit on Tele Radio?
If the yellow LED on your Tele Radio receiver, which indicates correct supply voltage, isn't lit, it could be due to: * Incorrect operating voltage. Check the operating voltage. * A blown fuse. Replace the fuse.
Why receiver yellow LEDs do not flash on Tele Radio?
If the yellow LEDs on your Tele Radio receiver, which indicate the number of programmed transmitters, do not flash, it means that a transmitter has not been programmed on the receiver. Program the required transmitter.
Covers programming up to 10 individual PIN codes per transmitter.
Explains how to interlock/prioritize relay functions or buttons.
Step-by-step guide on starting the transmitter.
Instructions for starting the transmitter using a PIN code.
Procedure for turning off the transmitter.
Explains the charging process for the transmitter's battery.
Lists technical details for the 860RX receiver.
Guidance on proper installation of the receiver and antenna.
Procedure for removing all programmed transmitters from the receiver.
Steps to replace an existing transmitter with a new one.
How to unlock the receiver when no transmitter is available.
Method for unlocking the receiver using the logged-on transmitter.
Alternative method for unlocking the receiver via transmitter.
Guide to programming a 4-digit PIN code for the transmitter.
Instructions for modifying or deleting an existing PIN code.
Procedure to erase all programmed PIN codes.
How to use the function selector for various relay configurations.
Details function selections for the MIDI receiver model.
Details function selections for the MAXI receiver model.
Steps to program latched/toggling functionality for relays.
Explains the two stop function modes selectable via switch 5.
General| Brand | Tele Radio |
|---|---|
| Model | 860 |
| Category | Transmitter |
| Language | English |
To Next Page