Tele Radio TG-TX-MNL6 - Turn the Transmitter off; Login;Logout

3.WITHIN10SECONDS:PresstheRFIDtagagainsttheRFIDantennaabovethestopbutton
onthefrontofthetransmitter.Thebuzzerbeeps2timestoconfirmthatanRFIDtaghasbeen
shown.ThetopLEDlights(greenwhenthebatterycapacityisgood,redwhenthebattery
capacityispoor).

4.WITHIN3MINUTESFROMPULLINGOUTTHESTOPBUTTON:
Pressabuttontoselectthereceiver(s)thatyouwanttooperate.
Thereceiver(s)thatwasselectedinthelastsessionwillbeautomaticallyselected,whichis
indicatedbythecorrespondingLED(s)thatlightred.Ifnoreceiver(s)hasbeenselected,the
LEDsforallavailablereceiverswillflashred.Ifareceiverisselected,theLEDsnexttotheleft
andtherightstartbuttonsflashred.Ifnoreceiver(s)areselected,onlytheLEDnexttotheright
startbuttonflashesred.

5.Pressbothstartbuttonsatthesametime.
Thebuzzerbeeps.

6.Releasethestartbuttons.
Thebuzzerstopsbeeping.ThetopLEDflashes(greenwhenthebatterycapacityisgood,red
whenthebatterycapacityispoor).

7.WhenradiocommunicationhasbeenestablishedandtheRFIDtaghasbeenaccepted,LED1
lights(greenwhenthebatterycapacityisgood,redwhenthebatterycapacityispoor).
Ifradiocommunicationisnotestablishedwithin25seconds,thetransmitterturnsoff.IftheRFID
tagisnotaccepted,thedisplayshowsanerrormessage.



TURN THE TRANSMITTER OFF

1.Pressthestopbutton.
Thetransmitterturnsoff.Allrelaysdeactivate.



LOGIN/LOGOUT

Quick logout

NOTE!Whenthetransmitterhasestablishedradiocommunicationwithoneormorereceivers,
youcanmakeaQuicklogoutfromthosereceivers.NotethattheQuicklogoutwilllogthe
transmitteroutfromallreceiversthatareparticipatinginthesession.

NOTE!Ifyouneedtologoutatransmitterthatislostordamaged,itispossibletologoutfrom
thereceiver.Wedonotrecommendthiswayofloggingout.Contactyourrepresentativefor
assistance.

NOTE!Tobeabletocontrolareceiver,thetransmittermustberegisteredinthereceiver,and
loggedintothereceiver.Ifanothertransmitterisalreadyloggedintothereceiver,ithastobe
loggedoutbeforeanyothertransmittercanbeloggedin.Ifnotransmitterisloggedintoa
receiver,aregisteredtransmitterwillautomaticallyloginwhensendingradiosignalstothe
receiver.Thetransmitterwillstayloggedinuntilitismanuallyloggedout.Morethanone
transmittercanberegisteredinthereceiver,butonlyonetransmittercanbeloggedinatatime.

1.Makesurethatthetransmitterisstartedinoperatingmode.
- 11 -