Programming a transmitter to 1 channel - Both doors on one transmitter
(2 door installation)
Please note: you have 8 seconds to do this step, if you get a series of beeps you will
need to start the transmitter programming again.
1. Press P1 & P2 together & hold for a few seconds until L1 & L2 lights flash rapidly – you will hear a
long beep.
2. Press & hold the P2 (circled) button & at the same time press the selected button on your
transmitter.
3. The long beep will change to a rapid beep – this means the button is now programmed.
4. Release both buttons & test your transmitter.
5. The button chosen will operate as open/stop/close/stop.
6. Please repeat this process if multiple doors are to programmed into this transmitter.
Please ensure you follow each step before moving onto the next page
To Next Page
Loading...