Need help?Do you have a question about the Telecrane F24-10S and is the answer not in the manual?
Details on mounting F21 and F24 receivers, including dimensions and placement.
Explains dry relay contacts and how to connect power to them.
Procedure for inserting AA alkaline batteries into transmitters.
Step-by-step guide for starting F21-2S and F21-2D models.
Instructions for starting F21-4S, F21-4D, and F21-6S models.
Procedure for starting F24 models (excluding F24-12S/12D).
Instructions for starting F24-12S and F24-12D models.
Steps to follow in case of an emergency situation.
General safety rules for installation, operation, and maintenance.
Covers personnel, testing environment, equipment understanding, fall prevention, receiver mounting, crane features, load safety, signal strength, operator training.
Includes battery checks, safety key use, product testing limits, environmental exposure, and power down procedures.
Guidelines for transmitter storage, limit switch checks, adverse conditions, authorized service, and repair limitations.
Diagnosing a dead receiver by checking power supply connections.
Checking for a mainline contactor and its wire connections.
Diagnosing issues where relays close but no movement occurs, checking common wires.
Configuration of the auto-shut-down feature, default settings and range.
Setting pushbutton modes: momentary, interlocked, toggle, or On-Off.
Programming delay between first and second detents of two-step buttons.
Configuration options for the R0 relay function (momentary, toggle, inching).
Wiring diagram for the F21-2S model.
Wiring diagram for the F21-2D model.
Wiring diagram for the F21-4S model.
Wiring diagram for the F21-4D model.
Wiring diagram for the F21-6S model.
Wiring diagram for the F24-6S model.
General| Number of Channels | 10 |
|---|---|
| Operating Distance | up to 100 meters |
| Enclosure Protection | IP65 |
| Number of Buttons | 10 |
| Control Range | 100m |
| Battery | 2 x AA batteries |
| Model | F24-10S |
| Power Supply | 2 x AA batteries |
| Transmitter Power | 10mW |
| Material | Reinforced nylon |
To Next Page