Teledyne EHE User Manual

FOR YOUR SAFETY - This product must be installed and serviced by authorized person-
nel, qualified in pool/spa heater installation. Improper installation and/or operation can
create carbon monoxide gas and flue gases which can cause serious injury, property
damage, or death. Improper installation and/or operation will void the warranty.
H0205000A
Installation and Operating Data
WARNING
If these instructions are not followed exactly, a fire or explosion may result,
causing property damage, personal injury, or death.
Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
Installation and service must be performed by a qualified installer, service
agency or the gas supplier.
Installation and
Operation Manual
Hi-E
2
™
Model EHE
Gas-Fired Pool
and Spa Heater

Teledyne EHE Specifications

General

Category	Swimming Pool Heater
Model	EHE
Type	Electric
Fuel Type	Electric
Brand	Teledyne
Voltage	240 V

Summary

SECTION 1. General Information

1A. Introduction

Overview of the manual's purpose and scope for the Hi-E2 heater.

1B. Description

Details the Hi-E2 heater's features, efficiency, and certifications.

SECTION 2. Installation Instructions

2A. General Requirements

Outlines essential requirements for safe and satisfactory installation of pool heaters.

2C. Heater Location

Guidelines for selecting an appropriate and safe location for the Hi-E2 heater.

2D. Installation Clearances

Specifies minimum clearances required around the heater for safety and service.

2H. Condensate Disposal

Procedures for safely draining and disposing of acidic condensate.

2I. Gas Supply and Piping

Guidelines for connecting the gas supply and sizing the gas piping.

2J. Electric Wiring

Instructions for electrical power connections and safety grounding.

2K. Water Piping

Details on connecting the heater to pool/spa water systems.

2L. Start-up and Adjustment

Procedures for safely starting and adjusting the heater.

SECTION 3. Operating Instructions

3A. Start-Up Procedure

Steps for safely starting the heater after installation or shutdown.

3C. Lighting and Shutdown

Step-by-step instructions for lighting and shutting down the heater.

3E. Spa/Hot Tub Safety Rules

Important safety recommendations for using spas and hot tubs.

3G-2. Winterizing

Procedures for protecting the heater during winter to prevent freezing.

SECTION 4. Maintenance and Service

4A. General

General advice for qualified technicians performing service.

4E. Electrical Trouble Shooting

Procedures for diagnosing electrical issues in the heater.

4E-2. Control Circuit Trouble Shooting

Methods for troubleshooting the 24V control circuit and safety controls.

4F. Venturi Combustion Flow System

Overview of checking air and gas flow within the venturi system.

4G. Combustion Condensate

Details on the condensate disposal system and its maintenance.

SECTION 5. Capacities and Dimensions

5A. General Information

General specifications and certifications for the Hi-E2 heater.

SECTION 6. Replacement Parts

6A. Parts List

A list of available replacement parts for the Hi-E2 heater.