To Next PageTo Next Page
Need help?Do you have a question about the Teledyne TDMC+ and is the answer not in the manual?
General| Brand | Teledyne |
|---|---|
| Model | TDMC+ |
| Category | Battery Charger |
| Language | English |
Safe battery connection, polarity, and reverse polarity error.
Overview of screen layout, voltage, current, and end condition selections.
Using the 'Go!' button to start the charging process.
Describes the TDMC+ as a 12V/24V lead-acid charger with advanced methods and features.
Identifies the TDMC-01 unit, power cord, and universal battery charge cable.
Safety guidelines for handling, charging, and maintaining batteries.
Guidelines for placing and operating the charger in a suitable environment.
Rules for using the power cord and grounding for electrical safety.
Ensuring DC cables are in good condition and properly connected.
Rules for operating the charger and handling damage or service needs.
Personal safety measures when working with batteries and the charger.
Details the charger screen organization (sections A-F) and its displayed information.
Explains charger status indicators and common error messages (Rev Polarity, Not Connected, etc.).
Describes specific error conditions like Over-Temp, Under-Volt, and Timeout.
Outlines the four possible states: Not Charging, Charging, Charging Paused, Charge Completed.
Explains how to use the buttons (A-D) to advance selections.
Describes the meaning of the Status LED (Off, Red, Red/Green, Green).
Describes the meaning of the Connection LED (Red, Red/Green, Green).
Describes the meaning of the Charge Stage LED (Off, Red, Red/Green, Green).
Describes the meaning of the Fault LED (Red, Red/Green, Green).
Guide for configuring the three-stage charge for normally discharged batteries.
Explains the three stages: Bulk Charge, Absorption, and Float Charge.
Steps to configure the two-stage charge for deeply discharged batteries.
Methods (equation and table) for determining the charge time for this mode.
Describes the two stages: Constant Current (Bulk) and Constant Voltage (Absorption).
Lists general specifications like charging current, voltage regulation, and efficiency.
Details absorption voltage, float voltage, and overvoltage protection for 3-stage charging.
Details duration and absorption voltage for 2-stage charging.
Compliance statement regarding FCC rules for radio frequency interference.
How the charger retains its settings between cycles and power-offs.
Procedure to check the charger's software version by button presses.
Lists equipment needed for the field test procedure.
Step-by-step instructions for verifying charger operation and sensor calibration.
