Sheet 21
10. PRECAUTION
10.1 ASSEMBLY AND HANDLING PRECAUTIONS
1
Do not apply rough force such as bending or twisting to the module during assembly.
2
To assemble or install module into user's system can be in clean working areas. The dust and
oil may cause electrical short or worsen the polarizer.
3
It's not permitted to have pressure or impulse on the module because the LCD panel and Bac-
klight will will be damaged.
4
Always follow the correct power sequence when LCD module is connecting and operating.
This can prevent damage to the CMOS LSI chips during latch-up.
5
Do not pull the I/F connector in or out while the module is operating .
6
Do not disassemble the module.
7
Use a soft dry cloth without chemicals for cleaning, because the surface of polarizer is very
soft and easily scratched.
8
It is dangerous that moisture come into or contacted the LCD module, because moisture may
damage LCD module when it is operating.
9
High temperature or humidity may reduce the performance of module. Please store LCD mo-
dule within the specified storaged conditions.
10 When ambient temperature is lower than 10 ℃ may reduce the display quality.
10.2 SAFETY PRECAUTIONS
1
The LED LightBar voltage of Backlight is can't exceed out Volts Spec, otherwise it may cause
electrical shock.. Do not disassemble the module or insert anything into the Backlight unit.
2
If the liquid crystal material leaks from the panel,it should be kept away from the eyes or mouth,
in case of contact with hands, skin or clothes, it has to be washed away thoroughly with soap.
3
After the modlule's end of life, it is not harmful in case of normal operation and storage.
EXPRESS LUCK INDUSTRIAL LTD.
Production specification
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn
To Next Page
Loading...
Need help?
General