Press one time on this ON/OFF button to switch on the appliance.
After 250 hours of use, this light function will illuminate to indicate that
the filters need to be cleaned.
Press this button once after cleaning the filters to reset the 250h cycle.
Note: The light stays on until you press it again.
Up button for temperature or timer:
* each pressure increases by 1 ° C in cooling mode
* each pressure increases the adjustment step of 30min or 1h
This button does not work in ventilation and auto mode.
Down button for temperature or timer:
* each pressure decreases by 1 ° C in cooling mode
* each pressure decreases the adjustment step of 30min or 1h
This button does not work in ventilation and auto mode.
Press on this button until the light of the selected mode illuminate:
Cooling mode: for setting the temperature between16°C and
32°C.
Press up and down button to your desired setting.
Press on the fan speed to select your desired fan speed.
When you set the air conditioner in AUTO mode, it will
automatically select cooling, or fan only operation
depending on what temperature you have selected and the
room temperature. The air conditioner will control room
temperature automatically round the temperature point
set by you.
Fan mode only.
Press up and down button to your desired setting.
The fan will run at the selected speed and the display will show
the room temperature.
Dehumidifier mode: the temperature is set to 25°C and fan
speed on low.
Temperature and fan speed cannot be set on this mode.
Keep doors and windows closed for best effect.
Note: the fan and the dry mode do not need the use of the exhaust hose.
Sleep mode: automatic program to save energy consumption with low fan
speed in cooling mode. It will run for 8 hours then the unit will return to
the initial setting. It can be cancelled at any time by pressing the button
again.
Note: This mode cannot be started for the fan mode or dehumidification
function.
To Next Page
Loading...
Need help?
General
