Instruction Manual
4
Maintenance and care
Switch off the unit, unplug from the power
supply. The outside of the appliance can be
cleaned with a slightly damp cloth.
Accessories
1 pc
Radio
Instruction manual
1 pc
Specifications
Specifications and functions are subject to change without notice. It is connected with continual
improvement of the device.
MANUFACTURED AND DISTRIBUTED BY TECHNO ELECTRIC LIMITED,
Legal address: 801 Luk Yu Building, 24 - 26 Stanley Street, Central, China
TELEFUNKEN and the TELEFUNKEN logo are trademarks of TELEFUNKEN Licenses
GmbH and are used under a trademark license.
Nominal voltage
~220 V, 50 Hz
Nominal power consumption
3.5 W
Battery power supply (backup) 3 V (1.5 V x 2 AA UM-3 batteries)
Net weight
0.23 kg
Unit dimensions
140 x 85 x 70 mm
Radio frequency FM: 87.5 - 108 MHz
Radio
4
• Press the VOL+/- buttons to adjust
the volume level.
•
Press /AUTO to turn the radio on or
off.
• Press and hold the AUTO button to start
an automatic search of
radio
stations.
For
a better FM reception, fully
extend the
FM
wire
antenna. The unit will save
2
0 FM
and stations.
Sleep/Nap functions
• In radio mode, press the SLEEP
button to turn on sleep mode. Press this
button repeatedly to select the sleep time
period (5-120 minutes) or to switch it off. The
radio will turn off automatically after the sleep
time period elapses.
• In standby mode, press
NAP
button to
enable the nap function. This function wakes
you up after a short period of time (5-120
minutes). Only the buzzer may be selected.
Press NAP or STANDBY to cancel.
Snooze control
• When the alarm is on, press the SNOOZE
button to interrupt the alarm signal. After
9 minutes the alarm will be on again.
• If you want to stop the alarm, press
or AL1/AL2 button. The alarm will resume in
24 hours.
• To cancel the alarm press the AL1/AL2
button. The alarm indicator will turn off.
•
Adjust the program by pressing
UP and
DOWN
buttons. Press and hold these buttons
to automatically scan to the next radio station
with strong signal.
•
To manually save a radio station,
first tune to the station you want to save
with
UP/DOWN buttons. Press the MEMORY
button. P01 will blink on the display. Use the
UP
and
DOWN
buttons to select the
memory preset (1-20). Press MEMORY to
confirm. Repeat this for other stations.
To Next Page
Loading...
