Televes OLT 769401 - Nodes, Sub-Nodes and Commands; Acl Node; Config Command

Descripción del producto
190
+ igmp[@show]
+ services[@availableValues, @cong, @create, @remove, @show, @showcong]
+ rate-limiters[@cong, @show, @showcong]
+ statistics[]
+ counters[@availableValues, @show, @show-active, @start, @stop]
+ dhcp[@availableValues, @show]
+ igmp[@availableValues, @show]
+ synchronism[]
+ global[@cong, @show, @showcong]
+ sources[@availableValues, @cong, @show]
+ ptp[@cong, @show, @showcong]
+ port[@availableValues, @cong, @create, @remove, @show, @showcong]
+ ip-access-list[@cong, @create, @remove, @show]
+ status[]
+ global[@command, @show]
+ sources[@command, @show]
+ ptp[@show]
+ users[@cong, @create, @remove, @show, @status]
7.6 Nodes, Sub-Nodes and Commands
7.6.1 “acl” node
/cli/acl> tree
+ acl[@cong, @create, @remove, @show, @showcong]
+ interface[@add, @cong, @remove]
+ network-service[@add, @cong, @remove]
+ rule[@cong, @remove]
+ rule-ipv4-ext[@cong, @create, @show]
+ rule-ipv4-std[@cong, @create, @show]
+ rule-ipv6-ext[@cong, @create, @show]
+ rule-mac[@cong, @create, @show]
Figure 7-22: “acl” node tree
7.6.1.1 “cong” command
Name cong
Description Congure parameters for an existing ACL.
Full path /acl/cong
Mandatory Parameters --ID
Screen Output No
Table 7-5: “cong” command information