EasyManua.ls Logo

Telit Wireless Solutions LM940 - Page 63

Telit Wireless Solutions LM940
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LM940 Hardware Design Guide
1VV0301352 Rev. 18 Page 63 of 75 2022-01-04
Not Subject to NDA
Mode
Band
Antenna Gain (dBi)
FDD 2600 B7
FDD 700a B12
FDD 700c B13
FDD 700b B17
FDD 1900+ B25
FDD 850+ B26
FDD 700d B29
FDD 2300 WCS B30
FDD AWS-3 B66
TDD 2600 B38
TDD 2500 B41
4.0
3.0
3.0
3.0
3.5
3.0
3.0
1.5
3.5
4.0
4.0
WCDMA
1900 PCS B2
1800 AWS-1 B4
850 B5
3.5
3.5
3.0
Table 23: RF Exposure
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
L'émetteur ne doit pas être colocalisé ni fonctionner conjointement avec à autre antenne
ou autre émetteur.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.

Other manuals for Telit Wireless Solutions LM940

Related product manuals