Telit Wireless Solutions LM940 - Page 73

LM940 Hardware Design Guide
1VV0301352 Rev. 18 Page 73 of 75 2022-01-04
Not Subject to NDA
15. DOCUMENT HISTORY
Revision
Date
Changes
18
2022-01-04
Template updated
Minor editorial changes
17
2020-11-04
Correct the typo 6.6.2
SIMVCC2 : Pin 6 -> Pin 16
SIMRST2 : Pin 16 -> Pin 6
16
2020-08-25
Changed the description of the difference between LM940 1.0 and 2.0
- Applicability Table
- 3.1 Pin-out
- 6.2 Power On
6.3.3 Unconditional Shutdown
15
2020-05-11
CA combo table header corrected
14
2020-02-05
Moisture Sensitivity Level Declaration removed
13
2020-01-21
Moisture Sensitivity Level corrected
12
2019-07-18
Band and CA combinations tables updated
11
2019-06-14
Moisture Sensitivity Level paragraph added
10
2019-05-28
Editorial changes
9
2019-05-28
Deleted some sentence in 2.1 Overview
Deleted some words in 2.4 Main features
Updated 6.3.2 Fast Shutdown Timing
8
2019-03-15
6 Digital Section
Changed description about setting GPIO as specific function.
Updated 6.2 Power ON
Updated 6.3 Power Off
Fast Shutdown Trigger: Low Edge Trigger
Updated 6.4 Reset
Added 6.5 Dying Gasp
Dying Gasp Trigger: Low Edge Trigger
Added and updated 6.6.4.2 WAN_LED_N
Added 6.6.5.3 Dedicated I/O
According to the merging LM940 1.0 and LM940
Design guide, following sections are changed.
Applicability Table, Section 3, Section 6.6.2, Section 9.3