Need help?Do you have a question about the Telwin Leader220 and is the answer not in the manual?
General| Input Voltage | 230 V |
|---|---|
| Output Current | 20 A |
| Charging Type | Automatic |
| Weight | 3.5 kg |
| Battery Capacity Range | 20 Ah - 200 Ah |
| Output Voltage | 12V/24V DC |
| Charging Modes | Maintenance |
| Protection Features | Overload, Short circuit, Polarity reversal |
Explanation of the danger of explosion warning sign for battery chargers.
Explanation of the general hazard warning sign for battery chargers.
Explanation of the danger of corrosive substances warning sign.
Symbol indicating separate collection of electrical and electronic appliances for refuse.
Warning about explosive gases produced during charging and the need for ventilation.
Requirement for proper instruction and supervision for untrained or impaired users.
Battery charger must be used indoors in airy places and kept away from rain or snow.
Disconnect mains cable before connecting/disconnecting charging cables from battery.
Components can cause arcs/sparks; use in garages requires a suitable case.
Ensure power outlet is protected by an earth connection for class I equipment.
Manual chargers for lead-acid batteries (WET) used in vehicles, motorcycles, boats.
Electronic chargers for sealed (GEL, AGM) and lead-acid (WET) batteries.
Instructions for unpacking and assembling the battery charger components.
Guidance on positioning the battery charger for stable operation and ventilation.
Connecting the battery charger to the main power supply, including voltage and fuse checks.
Steps for preparing lead-acid batteries before charging, including checking electrolyte levels.
Procedure for connecting the battery charger clamps to the battery terminals.
Method for manual charging of free electrolyte lead acid batteries (WET).
Recommended method for charging sealed batteries (GEL, AGM) using TRONIC mode.
Guidelines for charging multiple batteries simultaneously in series or parallel.
Procedure for safely disconnecting the battery charger after charging is complete.
Connecting the charger for vehicle starting, ensuring correct voltage and battery condition.
Procedure for using the 'START' function to start a vehicle engine.
Procedure for using the 'BOOST&GO' function for vehicle starting.
Steps to follow after completing the vehicle starting operation.
Advice on cleaning battery terminals and preventing clamps from shorting.
Consulting vehicle manual when battery is permanently installed.
To Next Page