Temp-Cast 2000 - Temp-Cast LLC Warranty Details; Warranty Period and Exceptions; Warranty Conditions; Warranty Registration Card

Temp-Cast Owner's Manual
September 2012
16
SECTION IX: WARRANTY
TEMP-CAST LLC WARRANTY
REGISTRATION CARD
NAME:
STREET ADDRESS:
CITY:
STATE/PROV:
ZIP/POSTAL:
EMAIL:
HOME TEL:
BUS TEL:
CELL#:
PURCHASE DATE:
INSTALL DATE:
DEALER:
INSTALLER:
INSTALLER CITY:
INSTALLER PHONE:
OPTIONS INSTALLED:
PRIMARY PURPOSE?
Main Heat Source □
Zone/Supplementary Heat Only □
Decorative Fireplace □
Other□
FAÇADE MATERIAL:
FAÇADE THICKNESS:
HOUSE TYPE:
Frame □
Log □
Timer Frame □
Post & Beam □
Straw Bale □
Earth/Adobe □
Concrete □
Other □
HOUSE STYLE:
Bungalow □
2 Storey □
3 Storey □
Split Level □
Other □
TOTAL HOUSE SIZE:
AREA HEATED BY TEMPCAST:
COMMENTS: (use reverse also)
FIVE Years from date of purchase
One Year from date of purchase
WARRANTY PERIOD
• Refractory Parts:
• Metal Parts:
Temp-Cast LLC warrants, subject to the conditions and exceptions noted below, that should this
product become defective due to materials or workmanship within the specified warranty period,
Temp-Cast LLC will repair or replace the defective part, at its option.
EXCEPTIONS
The following are not covered by this warranty:
1. Stress cracks in the refractory caused by normal thermal expansion.
2. Defects or cracks of any kind in the masonry facade.
3. Any other materials or labour, including removal and replacement of masonry facades.
4. Damage caused by incorrect installation, or by failing to follow Temp-Cast installation instructions.
5. Damage caused by incorrect operation or abuse, or by failing to follow Temp-Cast curing and operating
instructions.
CONDITIONS
1. Registration Card must be completed and mailed within 30 days of installation to Temp-Cast LLC, 8820
Grey Cloud Island Dr. S, St. Paul Park, MN 55071.
2. At least 4 Installation Photos (or video) must be included with the Registration Card, showing the
completed core, the core with partial facade erected, the completed installation and one showing a normal
fire, following the curing process - this photo can be sent separately at a later date.
3. All defective parts must be properly crated and shipped pre-paid to the Factory.
4. Proof of Purchase must be included, showing the date of retail purchase.
5. Temp-Cast must be contacted for approval prior to any part being returned for warranty claim.