Tempest POWER BLOWER - Page 12

Power Blower Data continued…
ELECTRIC MOTORS:
All electric motors are single phase, 60
Hz, rigid base, 56 frame, with ball
bearings and manual reset overload
protection.
ELECTRIC
UNITS
ENGINE HP CFM S/B RPM WIDTH DEPTH HEIGHT LBS
EB-12 ELECTRIC 1 TEFC 7,683 N.A. 3,450 16.00 19.50 21.50 45
EBS-16 ELECTRIC 1/3
TEFC
3,200 N.A. 1,736 18.75 14.25 19.50 47
EBS-16M
(W/MISTER)
ELECTRIC 1/3
TEFC
3,200 N.A. 1,736 18.75 14.25 19.50 47
EB-16 ELECTRIC 1.5
TEFC
11,804 6 3,450 18.50 20.00 20.50 66
EB-18 ELECTRIC 1 TEFC 8,748 6 1,750 22.25 21.00 24.00 71
EB-21 ELECTRIC 1 TEFC 11,698 7 1,731 25.00 21.00 26.00 72
EB-24 ELECTRIC 1 TEFC 12,867 7 1,736 28.25 22.50 30.00 75
EB-36 ELECTRIC 1 TEFC 13,281 8 1,750 41.50 24.50 43.50 94
Electric Blower Power Requirements*
Based upon 115 v blower on a 20 amp circuit.
BLOWER MODEL MOTOR
HP
STARTING
AMPS
STARTING
WATTS
RUNNING
AMPS
RUNNING
WATTS
EB-12 1.0 48 6,000 16 1,900
EB-16 1.5 54.6 6,300 18.2 2,100
EBS-16 1/3 10.9 1,300 6.3 756
EB-18 1.0 48 6,000 16 1,900
EB-21 1.0 48 6,000 16 1,900
EB-24 1.0 48 6,000 16 1,900
EB-36 1.0 47.3 6,000 12.1 1,452
*Starting amps and watts are momentary
Maximum Power Cord Length (in feet)**
MOTOR H.P. 14 GAUGE 12 GAUGE 10 GAUGE 8 GAUGE 6 GAUGE
1/3 215’ 330’ 550’ 850’ 1,350’
1.0 60’ 95’ 150’ 240’ 380’
1.5 45’ 1.75’ 115’ 190’ 300’
**Calculations based upon one blower connected to 20 amp circuit.
General Information 3.5