Maintenance Procedures continued…
4. Make sure the spark plug washer is in good
condition, and hand start the spark plug to prevent
cross threading.
5. After the spark plug is seated, tighten with a spark
plug wrench to compress the washer.
CARBURETOR
All carburetors comply with federal & state
regulations and are preset by the engine
manufacturer. Engine performance may differ at
various altitudes and climates. If you feel that the
carburetor on your blower needs adjusting contact
Tempest Technology or your local engine dealer.
EMISSION CONTROL SYSTEM
State regulations require that all manufacturers of
gas powered engines furnish written instructions
describing the Operation and Maintenance of the
emission control systems. These instructions vary
depending on engine type. Please refer to your
engine Operation and Maintenance Owners
Manual under the heading “Emission Control
Systems” for specific information and
instructions.
BELT ADJUSTMENT
Fi
ure 4.1
The blower drive belt has been adjusted at the
factory prior to delivery. However, the belt should
be inspected and checked after the initial three (3)
hours of operation as it may require retightening
due to belt stretch. It should be inspected after
Maintenance 5.4
To Next Page
Loading...
