Temsa TS 35 - 3. PROCEDURES; 3.3 USING PAINT - PRIMER - WAX GUNS; 3.3 USING INFRARED HEATERS

They use pressurized air to
atomise the paint, primer and wax.
Depending on the application, two
types can be used as upper loaded
chamber and lower loaded chamber
type can be used depending on the
application type.
Infrared heaters can be used to dry zones locally.
When using infrared heaters, DO NOT subject the
heaters to the surfaces to be dired continuously.
It may cause overheating of the surfaces.
The distance between heater and the surface to
be dried is important. Refer to the user manual
of the heater for such technical information
before using it..
3.3 USING PAINT - PRIMER - WAX GUNS
3.3 USING INFRARED HEATERS
CAUTION
CAUTION
Paint, primer and wax guns uses
pressurized air. Check system
pressure before operating them.
DO NOT stand in front
of the heaters.
3.PROCEDURES
76|TEMSA TS 35 Rev. 08/01.11.13