3.1.5.1 MASKING FOR BATCHING
3.1.5.2 MASKING FOR PAINTING
This masking procedure is used
before batching.
To avoid lining effect on the
boundaries reverse masking must
be applied.
Reverse masking is carried by
sticking the upside of the masking
paper and reversing its downside
towards vehicle and sticking it.
Hence, the lining effect between
paint and primer layers disappear.
Mask all of the surface to be
painted.
Use air guns to celan the surfaces
from dust and small particles.
Pressurized air helps to blow the
particles from the surfaces.
3.1.5 MASKING
3.2 USING AIR GUN
CAUTION
CAUTION
Before using the air gun check
the system pressure. Ensure that
min. system pressure is 5 bar.
Check and ensure that masking
tape used for masking does
not damage the surface of the
vehicle.
3. PROCEDURES
TEMSA TS 35 |75Rev. 08/01.11.13
To Next Page
Loading...
