Temsa TS 35 - 5. PROCEDURE FOR ENGINE COMPARTMENT (ZONE A); 5.1 ENGINE & COVERINGS

5.1 ENGINE & COVERINGS
5. PROCEDURE FOR ENGINE COMPARTMENT (ZONE A)
Corroded
Areas
CAUTION
CAUTION
CAUTION
CAUTION
Brush the corroded zone till the
uncoated metal surface can be
seen.
Poorly brushed surfaces may
cause paint failure and re-
corrosion.
When working with any
solvent, take the necessary
actions to prevent re risk.
Mask the necessary zones
before applying the primer.
Wait at least 45 minutes
after applying primer to the
surfaces.
Solvent
Clean the surface with a solvent.
Dry the surface with a new dry cloth.
Throw away the cloth
Apply this procedure min. 3 times.
If any corrosion is observed on the engine
or the coverings ;
1. Brush the corroded zone with wire
brush.
2. Clean the brushed area with gasoline
or any appropriate spray material to
clean the engine.
3. Apply heat resistant paint approved
by engine manufacturer.
4. Paint the zones with a suitable color
code (in accordance with engine
type & model) and use with hardener
Gromalit 2pack.
78|TEMSA TS 35 Rev. 08/01.11.13