Temsa TS 35 - 7. PROCEDURE FOR SIDE PANELS & REST OF VEHICLE (ZONE C); 7.2 PROCEDURE FOR WINDOW SIDE CORROSIONS

If any corrosion is observed on window
side;
1. Remove the sealer from the corroded
zone.
2. Brush the corroded zone with wire
brush.
3. Clean the brushed area with a solvent
or thinner and dry it with a dry cloth.
4. Mask the necessary zones.
5. Apply 2K Epoxy Primer primer to the
cleaned and dried zones. Wait at least
12 hours, or use infrared heater to dry
the zone.
6. Paint the treated zone with 2K black
paint by using spray painting.
7. Wait at least 45 minutes to ensure
surfaces are dried well.
8. Apply sealer to the gap between side
panel and window prole.
Terostat 8599 should be used for this
action.
window
sealer
REMOVE SEALER BY USING
SEALER CUTTING MACHINE
CHOCK
GRINDERS
APPLY SEALER
5 mm
7.2 PROCEDURE FOR WINDOW SIDE CORROSIONS
7. PROCEDURE FOR SIDE PANELS & REST OF VEHICLE (ZONE C)
CAUTION
Only use adhesive (sealer) in a
well ventilated area. Adhesive
is poiseness, do not swallow or
breath, keep away from eyes and
skin it can cause injurys.
WAIT
hours
12
TEMSA TS 35 |85Rev. 08/01.11.13