LED Descriptions
Solid blue
Solid red
Off
The repeater does not connect to your WiFi router/
modem.
The repeater is too far away from the router/modem.
Relocate the repeater closer to the router/modem.
The repeater has connected to your existing WiFi
router/modem, and its position is proper.
On
Blinking
Off
A WPS connection has been established.
A WPS connection is being established.
The WPS function is disabled.
Solid on
The repeater has started.
The repeater is starting.
The repeater is not powered on.
Off
Blinking
2 . Wait until the Signal LED on the repeater turns solid blue or red. If not, try Method 1.
Extend Your WiFi Network
1. Press the WPS button on the router and within 2 minutes press the WPS button
on the repeater.
Press
4. Select a WiFi network (SSID) you want to
extend.
5. Enter the password of the WiFi network
you want to extend. Set your repeater's
SSID (optional), and click Extend.
Select a WiFi network you want to
extend…
My_home_wifi
Rescan Switch Mode
Your existing WiFi network
Enter the password of “My_home_wifi”
My_home_wifi_EXT
Password of the extended network is
same as your existing WiFi network.
The extended WiFi network
SSID
Back Extend
2. Start a web browser, enter re.tenda.cn or
192.168.0.254 in the address bar to log in.
Wait a moment, the Extended successfully!
page appears.
4
Connect to the Internet
Connect your WiFi devices to the repeater
using the SSIDs set by yourself, or your
router's/modem's SSID with the suffix _EXT,
and using the WiFi password same as your
existing WiFi network.
You can use Method 2 if your router/modem has a WPS button, which
may be indicated by , , or . Otherwise, use Method 1.
Model: A301
Method 1: Extending Your WiFi Network Using Web UI
Quick Installation Guide
N300 Mini WiFi Repeater
Signal LED
WPS LED
PWR LED
1
Power on the Repeater
Plug the repeater into a power
outlet near the router in the
same room.
Method 2: Extending Your WiFi Network Using WPS
2
Wait until the PWR LED turns
solid blue.
1
Power on the Repeater
Plug the repeater into a power outlet
near the router in the same room.
Wait until the PWR LED turns solid blue.
PWR
PWR
Password (5-32 characters)
Confirm
Next Not Now
re.tenda.cn
2
Extend Your WiFi Network
1. Connect your WiFi device to the repeater's
WiFi network Tenda_EXT.
WLAN
Tenda_EXT
3. Create a login password for later login
(recommend).
Ensure that the Mobile Data (if any)
function of your WiFi device is disabled.
3
Relocate the Repeater
1. Plug the repeater into an outlet halfway between
the router/modem and the WiFi dead zone.
The location you choose must be within the range
of your existing WiFi network.
2 . Wait until the Signal LED turns blue. If not, relocate
the repeater closer to the router/modem.
For better performance, follow the on-screen tips or
the steps below to relocate your repeater.
WiFi router/modem
Signal
Blue: Good connection
Red: Bad connection
A301
Antennas upward
and vertical to the
ground
To Next Page
