English
05
Access the Quick Setup page to set the CPE to WISP
mode by following the onscreen instructions. Wait until
the CPE reboots to activate the settings.
When the LED1, LED2, and LED3 indicators of the CPE are
blinking, the CPE is connected to the ISP hotspot successfully.
The connection quality reaches the best when the LED1,
LED2 and LED3 indicators of the CPE blink.
2. Install the CPE
Place the CPE over the roof.
Thread the two plastic straps through the pole mounting
slots on the bracket of the CPE, and attach the CPE onto
the selected pole. Adjust the CPE’s location and direction,
and tighten the straps to fix the CPE.
Power on the CPE.
Connect the LAN port of the CPE to the WAN port of your
wireless router.
❶
❷
❸
❹
Pole mounting is used for illustration here.
Step2:
Wireless router
WAN
CPE in WISP Mode
ISP Hotspot
CPE (Example: OS3)
To Next Page
Loading...
Need help?
General
