Need help?Do you have a question about the Tenda O3 and is the answer not in the manual?
General| 5 GHz | No |
|---|---|
| 2.4 GHz | Yes |
| Number of users | 15 user(s) |
| Transmitting power | 29 dBmW |
| Networking standards | IEEE 802.11b, IEEE 802.11g, IEEE 802.11n |
| Receiver sensitivity | MCS0: -88dBm MCS7: -72dBm |
| Maximum outdoor range | 5000 m |
| Maximum data transfer rate | 150 Mbit/s |
| USB 2.0 ports quantity | 0 |
| Ethernet LAN (RJ-45) ports | 1 |
| Placement | Wall |
| Certification | FCC / CE / RoHS |
| Product color | White |
| LED indicators | LAN, Power, WAN |
| International Protection (IP) code | IP64 |
| Antenna features | Integrated antenna |
| Antenna gain level (max) | 12 dBi |
| Output current | 1 A |
| Output voltage | 12 V |
| Power consumption (max) | 6 W |
| Security algorithms | WPA, WPA2, WPA2-PSK |
| Cables included | LAN (RJ-45) |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | -20 - 55 °C |
| Operating relative humidity (H-H) | 10 - 90 % |
Weight and Dimensions| Depth | 94.86 mm |
|---|---|
| Width | 270 mm |
| Height | 67.5 mm |
Steps to log in to the device's web UI for initial access or after a reset.
Sets up the CPE to function as an Access Point, creating a new wireless network.
Configures the CPE as a wireless adapter to connect to an existing upstream AP.
Example for CCTV surveillance setup using AP and Client modes.
Extends wireless network coverage by repeating the signal from an upstream AP.
Connects wirelessly to an ISP hotspot to provide internet access.
Example of extending ISP hotspot wirelessly using WISP mode.
Connects multiple wired networks wirelessly, supporting clients.
Connects multiple wired networks wirelessly, but not wireless clients.
Configures the CPE to act as a router, sharing network access.
Configure LAN port settings, device name, and IP address acquisition methods.
Configure SSID, network mode, channel, and security mode for wireless operation.
To Next Page
