Tenda O3 User Manual

91
6.2 MAC clone
This function is available only when the device works in WISP or Router mode.
6.2.1 Overview
If the CPE cannot access the internet after configuring internet settings, your ISP may have bound
your internet service account with the MAC address of your computer that was used to verify the
internet connectivity after you subscribed to the internet service. Therefore, only this computer
can access the internet with the account.
In this case, you need to clone the MAC address of this computer to the WAN port of the CPE for
internet access.
6.2.2 Clone a MAC address
Select one of the following methods to clone the MAC address according to your networking
scenario.
Use the computer with the MAC address bound to your internet service for setup
Step 1 Connect the computer to the device.
Step 2 Start a web browser on the computer connected to the CPE, visit 192.168.2.1 and choose
Network > MAC Clone to enter the configuration page.
Step 3 Click Clone Local MAC Address.
Step 4 Click Save.
----End
Use a device without the MAC address bound your internet service for setup
If you do NOT use the computer that can access the internet after it connects to the modem
directly to configure the CPE, but you know the MAC address of this computer, perform the
following steps:
Step 1 Connect a device (such as a smart phone or tablet) to the device.
Step 2 Start a web browser the device, visit 192.168.2.1 and choose Network > MAC Clone to
enter the configuration page.
Step 3 Enter the MAC address of the computer that can access the internet in the MAC Address
box.

Tenda O3 Specifications

General

5 GHz	No
2.4 GHz	Yes
Number of users	15 user(s)
Transmitting power	29 dBmW
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Receiver sensitivity	MCS0: -88dBm MCS7: -72dBm
Maximum outdoor range	5000 m
Maximum data transfer rate	150 Mbit/s
USB 2.0 ports quantity	0
Ethernet LAN (RJ-45) ports	1
Placement	Wall
Certification	FCC / CE / RoHS
Product color	White
LED indicators	LAN, Power, WAN
International Protection (IP) code	IP64
Antenna features	Integrated antenna
Antenna gain level (max)	12 dBi
Output current	1 A
Output voltage	12 V
Power consumption (max)	6 W
Security algorithms	WPA, WPA2, WPA2-PSK
Cables included	LAN (RJ-45)
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	94.86 mm
Width	270 mm
Height	67.5 mm